Electrical Connection - ETNA T301ZT Notice D'utilisation

Electrical connection

The model number, power supply and
connected load are specified on the data
plate.
The data plate is attached to the base of the
appliance.
The connection cable is of the type Y.
This means that the connection cable may
only be replaced by the manufacturer, the
service organisation or similarly qualified
persons, in order to prevent dangerous
situations.
If you want to make a fixed connection, make
sure that a multi-polar switch with a contact
separation of at least 3 mm is fitted in the
supply line.
Electrical connection
The appliance is delivered with a connection
cable. As standard, the connection cable has
a connection between the brown and blue
wires and between the grey and black wires.
In most cases you should remove these
connections.
blue grey
brown black
yellow/green
N L
230V
2 phase connection
2 positive + 2 negative 2 2N a.c. 230 V
Remove the connections.
The fuse box in your home must be fitted with
a 16 A fuse.
blue grey
brown black
yellow/green
N1 N2 L1 L2
230V
230V
negative connection N1 (blue)
negative connection N2 (brown)
positive connection L1 ( grey)
positive connection L2 ( black)
2 positive + 1 negative 2 2N a.c. 400 V
Remove the connection between the grey and
the black wire.
The fuse box in your home must be fitted with
a 16 A fuse.
grey
blue
brown black
yellow/green
N L1 L2
230V
230V
negative connection N (blue and brown)
positive connection L1 (grey)
positive connection L2 (black)
Do not connect the 3rd phase
The next deviant connections are possible too:
1 phase connection
1 positive + 1 negative 1N a.c. 230 V
The fuse box in your home must be fitted with
a 32 A fuse.
grey
blue
brown
black
yellow/green
N L
230V
negative connection N (blue and brown)
positive connection L (grey and black)