Table des Matières
Publicité
ELECTRICAL CONNECTION
General
The electrical connection must be carried out ONLY by qualified technicians.
The electrical protection of the electrical connection upstream of the equipment must comply
with the regulations in force.
The aspiration system is composed by two appliances:
▷
Connect the appliances to a permanent connection.
Make sure that the voltage (V) and frequency (Hz) indicated on the serial number plate
▷
located on the appliances correspond to those available at the installation site.
•
Any change to the electrical installation necessary to install the hood should only be
undertaken by competent person.
•
The electrical connection of the appliance must follow the diagram, according to the voltage
of the electricity network.
•
To make a fixed connection to the network, an omnipolar interruption device must be
interposed between the unit and the network. This device must ensure a separation of
contacts, providing a complete disconnection in the category III overvoltage conditions.
•
After installation, insulated parts and those carrying electricity must be protected from any
possible contact.
CAUTION! If the electrical connection is carried out incorrectly or not meeting the
regulations, it may damage part of the appliance and the warranty will not respond.
CAUTION! Before any intervention, disconnect the appliance from the power
mains.
These devices must be connected to an earthed system.
Electrical connection of the induction hob
The connection terminals can be reached after opening the conductors cover.
The plate with all the technical data is located at the bottom of the hob.
•
Connect the protective cable to the terminal marked with the earth cable symbol.
•
The connecting cable must pass through the bracket protecting it from accidental strain.
•
After connecting the appliance, turn on all cooking zones / heaters for approximately three
minutes to make sure they are operating correctly.
•
Connection cable on the back of the appliance should be led in such way that it does NOT
touch the appliance back wall, as this part will get very hot during operation.
EN 30
Publicité
Table des Matières
