Table; General - ETNA T301ZT Notice D'utilisation

Table

If the appliance does not work properly, this does not always mean that it is defective. Try to
deal with the problem yourself first by checking the points mentioned below:
You have observed the following: Possible causes:
The display lights up. Normal operation.
Only works on one side. The appliance is incorrectly
connected.
The fuse in the meter cupboard is
defective.
Continuous beep.
When first used a strange smell New appliance.
comes from the hob.
The hob does not work and the The appliance is receiving no
displays on the operating panel power. Defective power supply or
remain out. incorrect connection.
The hob does not work and an error The electrical circuit works poorly.
code F1, F2, F3 or F4 is displayed.
The hob does not work, the The hob is locked.
information or is
displayed.
The hob switches off during use, 4 Something has boiled over or there
dashes are displayed. is an object on the operating panel.
The electronic circuits are warm.
A series of small or F0 is
displayed.
Error code F0 Pan is boiled dry or to hot.
After switching on a cooking zone, The pan you are using is not
the operating panel display suitable for induction cooking or
continues to flicker. has a diameter of less than 12 cm
(10 cm for the 16 cm cooking zone).
Error code F5 or F6 Appliance overheated due to
insufficient ventilation.
The pans are noisy during cooking. Normal for certain types of pan. It is
Your cooking pan makes a ticking caused by the energy being
sound during cooking. transmitted from the hob to the pan
The ventilator continues to work for The electronics are cooling off.
several minutes after the hob has Normal operation.
been switched off.
Solutions:
Do nothing, the display disappears
after 30 seconds.
Check the electrical connection.
See electrical connection (page
100).
Warm a pan full of water for 30
minutes on each zone.
Check the fuses and the electrical
master switch.
Contact the Service Department.
See chapter on use of child
protection.
Clean the hob or remove the object
and then continue cooking.
See chapter on installation.
Let appliance cool down or continu
cooking on a lower setting.
See chapter on pans for induction
cooking.
Check the building-in situation or
contact the Service Department.
Do nothing. There is no danger for
the hob or for your pan.
Nothing.

General

In case of faults phone the service
department. See the guarantee certificate or
consult the internet site www.hps.nl.
If you notice a crack on the cooking
surface (no matter how little), switch
off the appliance immediately. Remove the
plug from the socket or set the switch of the
power supply cable (in the case of a fixed
connection) to zero or turn off the fuse
switch(es) in the meter cupboard.
Phone the service department.
This appliance should only be connected up
by a registered electrical installer!
The electrical connection must comply with
national and local regulations.
Damage caused by incorrect connection,
incorrect use or incorrect building in is not
covered by the guarantee.