Installation; General - Hatco GLO-RAY GR2SD Série Manuel D'installation Et D'utilisation

English

General

Glo-Ray Designer merchandising Warmers are shipped with
®
most components pre-assembled. Care should be taken when
unpacking shipping carton to avoid damage to unit and
components enclosed.
WARNING
ELECTRIC SHOCK HAzARD: unit is not weatherproof.
Locate unit indoors where the ambient air temperature is a
minimum of 70°F (21°C).
FIRE HAzARD: Locate unit a minimum of 2" (51 mm) from
combustible walls and materials. If safe distances are not
maintained, discoloration or combustion could occur.
Locate unit at the proper counter height in an area that is
convenient for use. The location should be level to prevent
the unit or its contents from falling accidentally and strong
enough to support the weight of the unit and contents.
The National Sanitation Foundation (NSF) requires that
units over 36" (914 mm) in width or weighing more than
80 lbs. (36 kg) either be sealed to or raised above the
installation surface. If unit cannot be sealed at the point of
use, 4" (102 mm) legs are included to allow for proper
cleaning access below unit.
Transport unit in upright position only. Before moving or
tipping unit, secure all glass surfaces with tape. Failure to
do so may result in damage to unit or personal injury.
1. Remove the unit from the box.
NOTE: To prevent delay in obtaining warranty coverage,
complete online warranty registration. See the
ImPORTaNT OWNER INFORmaTION section for
details.
2. Remove tape and protective packaging from all surfaces
of unit.
NOTICE
Do not lay unit on the side with the control panel. Damage
to unit could occur.
3. Carefully lay the unit on its side and install the four
Designer legs at each corner on the bottom of the unit. Two
people are required for this step.
a. Thread a hex bolt through the short rubber foot (bolt
head on recessed side of foot), through the Designer leg
and into the corner hole on the base. Tighten securely.
Installing the 4" (102 mm) Designer Legs
Form No. GR2SDm-0316
CAUTION
4. after all the legs are secure, return the unit to its upright
position. Two people are required for this step.
5. Install the channel dividers and product divider rods.
a. Position the channel dividers onto the locator pins on the
front edge and back edge of the unit.
b. Place the product divider rods into the channel dividers.
The bars can be adjusted easily to separate holding
areas as needed.
Locator Pin
Installing Product Divider Rods
6. Install the glass side panels on each side of the unit. To
install the side panels:
a. angle the top edge into the upper channel.
b. Carefully lower the bottom edge into the lower channel.
Do not allow the panel to drop into position.
Glass Side Panel
Lower Channel
Side Glass Panel Installation
7. Place the unit in the desired location. Two people are
required for this step.
• Locate the unit in an area where the ambient air
temperature is constant and a minimum of 70°F (21°C).
avoid areas that may be subject to active air movements
or currents (i.e., near exhaust fans/hoods, air
conditioning ducts, and exterior doors).
• make sure the unit is at the proper counter height in an
area convenient for use.
• make sure the countertop is level and strong enough to
support the weight of the unit and food product.
8. For units without plugs, have a qualified electrician install
proper plug or hardwire to on-site power source.
15

INSTALLATION

Product Divider Rod
Channel Divider
Upper Channel