Installation; General; Electric Shock Hazard - Hatco MVW Série Manuel D'installation Et D'utilisation

INSTALLATION

General

mini Vertical Warmers are shipped from the factory fully
assembled and ready for use. Use the following procedure to
install the unit.
WARNING

ELECTRIC SHOCK HAzARD:

• Plug unit into a properly grounded electrical receptacle
of the correct voltage, size, and plug configuration. If
plug and receptacle do not match, contact a qualified
electrician to determine and install proper voltage and
size electrical receptacle.
• Unit is not weatherproof. Locate unit indoors where
ambient air temperature is a minimum of 70°F (21°C).
FIRE HAzARD: Locate unit a minimum of 1" (25 mm) from
combustible walls and materials. If safe distances are not
maintained, discoloration or combustion could occur.
CAUTION
Locate unit at proper counter height in an area that is
convenient for use. Location should be level to prevent
unit or its contents from falling accidentally and strong
enough to support weight of unit and contents.
NOTICE
Do not locate unit in an area subject to excessive
temperatures or grease from grills, fryers, etc. Excessive
temperatures could cause damage to unit.
Do not locate unit in area with excessive air movement
around unit. Avoid areas that may be subject to active air
movements or currents (i.e., near exhaust fans/hoods, air
conditioning ducts, and exterior doors).
Damage to any countertop material caused by heat
generated from Hatco equipment is not covered under the
Hatco warranty. Contact manufacturer of countertop
material for application information.
1. Remove the unit from the box.
NOTE: To prevent delay in obtaining warranty coverage,
complete online warranty registration. See the
ImPORTaNT OWNER INFORmaTION section for
details.
2. Remove tape and protective packaging from all surfaces
of the unit.
3. Place the unit in the desired location.
• Locate the unit in an area where the ambient air
temperature is constant and a minimum of 70° F
(21° C). avoid areas that may be subject to active air
movements or currents (i.e., near exhaust fans/hoods,
air conditioning ducts, and exterior doors).
• make sure the unit is at the proper counter/wall height
in an area convenient for use.
• For countertop units: make sure the countertop is level
and strong enough to support the weight of the unit and
food product. make sure the unit is positioned securely
on the countertop.
• For wall-mounted units: make sure the unit is installed
using the proper hardware for either wood stud or
hollow-wall installation (refer to the OPTIONS aND
aCCESSORIES section for installation details).
4. Install any accessories that came with the unit. Refer to the
OPTIONS aND aCCESSORIES section for details.
6
English
Form No. mVWm-0515