Assembling Instructions; Simplified General Diagram; Assembling The Stand - Elite REALPOWER Mode D'emploi

WARNING. NOTE. DO NOT CONNECT THE USB KEY TO THE COMPUTER BEFORE
Illustration 1 shows the diagram of the RealPower. The parts in black are supplied in the RealPower box,
while the user must provide the parts in grey.
monitor
PC
USB key

ASSEMBLING THE STAND

• From the frame, remove the M8 screw that holds
the adjusting plate (Ref. X) in place. Assemble the
adjusting plate and the resistance unit plate (Ref.
V) with the M8 screw (Ref. BB) newly on the frame,
as show in illustration 2.
• The trainer base is supplied with two types of feet:
a) Standard feet (Ref. F);
b) Ritmo feet (Ref. E).
a) Illustration 3 shows how to fit the feet Standard
(Ref. F) to the stand (Ref. A). Use a rubber mallet

ASSEMBLING INSTRUCTIONS

INSTALLING THE REALPOWER SOFTWARE.
SEMPLIFIED GENERAL DIAGRAM
handlebar
console
Travel Block
2
cadence
sensor
resistance
unit
magnet
if necessary. Make sure that the bottoms of the
feet are parallel with the floor and that the stand
is completely open.
b) Illustration 4 shows how to fit the feet Ritmo
(Ref. E) to the stand (Ref. A). Use a rubber mallet if
necessary. Pay careful attention that the thread on
the Ritmo feet (Ref. E) is aligned with the indent on
the end part of the trainer base frame tubes (Ref.
A) as shown in figure 4a / 4b, make sure that the
bottoms of the feet are parallel with the floor and
that the stand is completely open.
EN
1
3
25