Safety Feature; Cleaning And Maintenance - EUROM C.U. 2000 Multi Manuel D'utilisation

Wind direction
You can adjust the airflow direction by turning the wind direction button.
Switch off
To switch the heater off, set the main switch to O (off); this will erase all settings.
Allow the appliance to cool down for 30 seconds and remove the plug from the
power socket. Always remove the plug from the socket if the heater is not working!
Attention! The heater remains hot for some time after use!

Safety feature

In case of internal overheating, the overheating safeguard will switch the heater
off. This may occur if the heater cannot give off enough heat or if it cannot draw in
enough fresh air. As mentioned above, this is generally caused by (partially)
covering the heater, obstructing the air intake and/or outlet grills or installing the
heater too close to a wall or something similar. When the overheating safeguard
switches the heater off, you must then switch off by means of the main switch.
Unplug and allow the heater to cool down. Remove and/or amend the cause of
overheating and use again, as normal. If you cannot find a cause and overheating
recurs, stop using the heater, and take it in for inspection/repair.

Cleaning and maintenance

Keep the heater clean. Deposits of dust and dirt in the appliance are a common
cause of overheating so these should be removed regularly. Switch off the heater,
remove the plug from the socket and allow the heater to cool down before cleaning
or carrying out maintenance work.
Wipe the outside of the heater regularly with a dry or slightly damp cloth. Do

not use aggressive soaps, sprays, cleaners or abrasives, waxes, polishes or
chemical solutions!
Open the cover of the dust filter (H, see fig.), remove the filter and beat it clean

or rinse it carefully. Allow it to dry very thoroughly
before putting it back!
Using a vacuum cleaner, carefully remove any dust

and dirt from the grills and ensure that the air
intake and outlet openings are clean. Be careful not
to touch or damage any internal parts during
cleaning!
The heater contains no other parts which need

maintenance.
Place the filter in the correct position and close the

cover again.
At the end of the season, store the cleaned heater in the original packaging if

necessary. Store it upright in a cool, dry and dust-free place.
30