LGB 99 7234-0 Instructions De Service page 21

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

65 = button 1 (on only when loco is reversing)
128 = lighting button 9 (on only when loco
is moving forward)
129 = button 1 (on only when loco is moving forward)
(depends on loco model, do not change, as functions
can be affected or destroyed).
CV52
Command for front lighting terminal (see CV51).
CV53
Command for rear lighting terminal (see CV51).
CV54
LGB configuration
Bit programming
Bit 1: hand-off function, 0 = off, 1 = on [0]
Bit 2: MTS Back-EMF, 0 = off, 2 = on [2]
Bit 3: analog Back-EMF, 0 = off, 4 = on [0]
Bit 4: load-dependent chuffs, 0 = off, 8 = on [0]
Bit 5: 0 = F1 constant, 16 = F1 flashing [0]
Bit 6: 0 = F2 constant, 32 = F2 flashing [0]
Bit 7: 0 = two chuffs/revolution, 64 = four chuffs [0]
Bit 8: automatic brake sounds, 0 = on, 128 = off [0]
To program, add the values for the individual Bits
and program the resulting function value.
The values for Bits 5-8 vary between locos.
The values for your loco can be read using the
55045 MTS PC Decoder Programming Module.
Hand-off function on:
When operating with 55015, you can adjust direction
and speed for two seconds after selecting a moving loco
without causing the loco to stop.
CV55
Reset factory pre-set values for CVs
Program:
6 - 55 ->
5 - 55 ->
CV56
Voltage for function terminal F2
(depends on loco model, do not change, as functions
can be affected or destroyed).
CV57
Command for function terminal F2 (see CV51).
CV58
Pause time (analog operation)
(0.5 seconds x function value)
When the polarity of the analog track voltage is reversed,
the loco waits for the programmed time period,
then accelerates in the new direction.
CV60
Back-EMF: Max. adjustment factor Specifies
the max. increase or decrease of voltage applied during
each time interval (programmed in CV61)
1 = small steps, 255 = large steps
The factory pre-set values of CV60 and CV61 are
optimized for LGB motors.
CV61
Back-EMF: Adjustment frequency
Specifies how often per second the motor voltage
is adjusted - accordingly, the loco will react to curves
and grades immediately or with a short delay
24
[128]
[64]
[10]
(1-32)
[5]
[15]
(0-255)
[0]
(1-255)
[4]

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

248112481299 7234-0 série

Table des Matières