LGB 99 7234-0 Instructions De Service page 20

You can program the following registers:
Register Function
CV1 Loco address
CV2 Starting voltage
voltage for speed setting 1 - if loco starts only at a higher
speed setting, increase value.
CV3 Acceleration (1 = fast, 255 = slow)
CV4 Braking (1 = fast, 255 = slow)
CV5 Max. voltage
Voltage for highest speed step - if a lower top speed
is desired, decrease value.
CV5 after input of CV6
(when programming with older 55015)
function value for CV to be programmed.
CV6 CV to be programmed
(when programming with older 55015).
CV29 NMRA configuration
Bit programming
Bit 1: direction, 0 = normal, 1 = reversed [0]
Bit 2: speed steps, 0 = 14 (LGB), 2 = 28 [0]
Bit 3: analog operation, 0 = not possible, 4 = possible [4]
Bit 4: not used [0]
Bit 5: speed steps, 0 = factory-programmed,
16 = user-programmed [0]
Bit 6: address area, 0 = 0-127 (LGB), 32 = 128-10039 [0]
To program, add the values for the individual Bits
and program the resulting function value.
Note: To program a loco to reversed direction of
travel (for example, F7 A-B-A combination),
program function value 5.
Attention !
speed steps cannot be used with LGB MTS).
CV49 Voltage for function terminal F1
(depends on loco model, do not change, as
functions can be affected or destroyed).
CV50 Voltage for lighting terminals (see CV49).
CV51 Command for function terminal F1
0 = lighting button 9
1 = button 1 (buttons 2-8 not used)
9 = button 1 (buttons 2-8 used as well)
10 = button 2
11 = button 3
12 = button 4
13 = button 5
14 = button 6
15 = button 7
16 = button 8
64 = lighting button 9 (on only when loco is reversing)
Loco addresses 128-10039 and 28
Available Factory
values pre-set
(00-22) [3]
(0-255) [2]
(1-255) [3]
(1-255) [3]
(1-255) [160]
[4]
(1-32) [32]
(1-32) [5]
[13]
23