Mounting The Bar And Chain - Stihl MS 192 T Notice D'emploi

Mounting the Bar and Chain

1
a
t = a : 2
You can run chains of different pitches
on this chainsaw – depending on the
chain sprocket (see "Specifications"):
The chain pitch (1) must match the guide
bar. The drive link gauge (2) must match
the guide bar groove width (3).
The pitch is marked in inches on
the sprocket and guide bar (e.g. 3/8
or .325) and the groove width is
additionally marked on the bar in
millimeters (e.g. 1.6).
Do not run non-matching
components together (different
pitches or drive link gauges) since
they will otherwise be damaged
beyond repair within a very short
period of operation.
MS 192 T
2
3
: Disengage the chain brake:
Pull the hand guard (4) toward
the handle.
6
: Unscrew the nut (5) and remove
the cover (6).
4
: Turn screw (7) counterclockwise
until the tensioner slide (8) butts
against left end of housing slot.
5
: Fit the guide bar over the stud (9)
and engage the peg of the tensioner
slide in locating hole (10).
English
7
8
9
10
19