Correct Use; Unpacking; Assembling; Lr-2.St Stand System - IKA LR-2.ST Mode D'emploi

The anchor stirrer must only be
NOTICE
operated at a speed of max.
300
You can use these in conjunction with labworldsoft
ratory software to create a high-performance system for
measuring, controlling, regulating and fully documenting
all laboratory processes.
Sample applications:
• Manufacture of cremes, lotions, emulsions and liposo-
me preparations in the pharmaceutical and cosmetic
sector (lipstick, sun cream, eyeliner).

Unpacking

- Unpack the device carefully
- Any damage should be notified immediately to the
shipping agent (post office, railway network or trans-
port company)
The LR-2.ST laboratory reactor system is supplied as a
fully functional unit in various configurations depending
on customer requirements. Accessories, such as ULTRA-
TURRAX, temperature gauges and reactor vessels are
supplied separately.

LR-2.ST stand system

The stand system holds the
NOTICE
drive unit complete with the
reactor cover and the stirring
instrument, the reactor vessel
and the safety disconnector.
An adjustment screw on the rear, right-hand side foot of
the stand can be used to level the stand and compensate
for any unevenness in the mounting surface.
Undo the lock nut. Turn the knurled screw clockwise to
slightly raise the foot of the appliance, turn it anticlockwise
to lower it. When the appliance is level, tighten the lock
nut.

Correct use

rpm.
®
Unpacking

Assembling

M8 cheese-head
screw with basepla-
te and side support
Adjuster
screw for
levelling
• Mixing of solids such as calcium carbonate, talc and
titanium oxide with liquid polymers.
• Mixing of additives and solid polymer compounds with
labo-
mineral oils.
• Dispersion and mixing of solids and fibres in liquids
and polymers.
• Manufacture of milk products and dietary products.
• Extraction of enzymes from biomass.
Scope of delivery
- LR-2.ST stand system complete with reactor cover
- Overhead stirrer
- LR-2.SI safety disconnector
If you are working with the LR 2.1 single-walled reactor
vessel and the HBR 4 digital heating bath, you must remo-
ve the baseplate including clamping bracket and one side
support from the stand.
Undo the top two M8 cheese-head screws using the DIN
911-6 cranked wrench key provided. Remove the basepla-
te, undo the bottom cheese-head screws and remove the
side support.
The remaining side support is used to fit the safety dis-
connector. Place the plastic cover onto the aluminium
profile.
Undo the knur-
led screw to
adjust the height
17