Unpacking
• Unpack:
- Please unpack the device carefully
- In the case of any damage a fact report must be set immedi-
ately (for post, rail or forwarder)
• Delivery scope:
- Tube Drive
- Power supply unit
- Removal hook
- Operating instructions
- A warranty card.
Correct use
• Use
Application
Mixing
with Tube ST-20...
with Tube ST-50...
Stirring
Dispersing
with Tube DT-20...
with Tube DT-50...
Stirring
Crushing
with Tube BMT-20...
with Tube BMT-50...
Mixing
wet/dry
• Range of use (indoor use only)
- Laboratories
- Schools
- Pharmacies
- Universities
This device is suitable for use in all areas except:
- Residential areas
- Areas that are connected directly to a low-voltage supply net-
work which also supplies residential areas.
The safety of the user cannot be guaranteed:
- If the device is operated with accessories that are not supplied or
- If the device is operated improperly contrary to the manufacture's
- If the device is operated improperly contrary to the manufacturer's
Changes in viscosity and volume caused by processing of disper-
sion media may cause small fluctuations in the speed of the device.
Pay attention to the ambient conditions listed in the "Technical
Data".
Volume
Mode
Position the rotating knob (B) at the left stop
2 - 15 ml
Seconds and
before starting up.
15 - 50 ml
minutes mode
5 - 15 ml
Seconds and
If these conditions are met, the unnit is rea-
15 - 50 ml
minutes mode
dy for service when the mains plug has been
2 - 15 ml
Seconds and
15 - 50 ml
minutes mode
plugged in.
Switching on:
Press "Power" button (A).
Previous mode and time settings will be dis-
played e.g. :
(Factory setting: -2)
recommended by the manufacturer
specifications
specifications.
Useful facts
Commissioning
13