Tulikivi KIPITTI Mode D'emploi page 15

area you have sanded. After sanding, clean the surface with luke-
warm water and dry carefully.
INSTRUCTIONS FOR GLASS COMPONENTS
Do not strike or slam your fireplace door. When glass is broken no-
tify directly your Tulikivi dealer and do not heat your fireplace. If
for any reason the door glass needs to be replaced, contact your
Tulikivi dealer. The manufacturer accepts no responsibility for any
unauthorized or unapproved changes, repairs or additions made
to fireplace structures.
CLEANING THE DOOR GLASS AND FRAMES
The doors of Tulikivi fireplaces have been designed so that the air
flow keeps the glass clean inside. If the glass gets soot on it, clean
it as soon as the fireplace has cooled. During firing the glass is hot.
Ash is an ecological cleaner that is always at hand. Pick up a
little ash from the ash box with a moistened towel and lightly rub
the area of the glass stained with soot. After this, wipe the glass
clean with damp towel and then carefully dry the glass (figure 9).
You can use the soapstone cleaner that comes with your fire-
place to clean the door frames. Never use solvent-based or abra-
sive cleaners.
The manufacturer accepts no responsibility for any unauthorized
or unapproved changes or additions made to fireplace structures.
7.
Only extra and spare parts that have been approved by the man-
ufacturer and properly installed are permitted for use with your
fireplace.
Troubleshooting
If there is no flue draft or your fireplace smokes during firing:
• Check that the damper (if one is installed) is open and that the
air control lever is set to the 'open' position.
• Check that there are no blockages preventing combustion air
from entering the fireplace.
• Turn off ventilation systems and cooker fans.
• Open the door or window of the room.
• If necessary, contact your authorized Tulikivi dealer.
If there is a chimney fire:
• Close the air control levers of the fireplace.
• Keep the firebox door closed.
• Contact local fire department immediately.
• Do not attempt to extinguish the fire with water.
• After a chimney fire, a chimney sweep must check both the fire-
place and the flue before the next firing.
8.
ENG
9.
15