Programming The Remote Control; Manual Electric Drive: Manned - Aprimatic APRIBOX 600 Notice D'installation Et D'entretien

Programming / Manned operation
5.4

PROGRAMMING THE REMOTE CONTROL

5.4 .1 RADIO START COMMAND (fig.26)
• Remove jumper JP1.
• Briefl y press button P1.
ON for a moment then switched OFF for 1 second and then
ON again: programming can begin.
• Press a button on the remote control you wish to program
(this button is used to transmit the START command via radio).
Warning light DL1 is switched OFF and the command is
programmed.
If a signal is not transmitted within 10 seconds after the
start of programming then programming ends.
Note: a maximum of 48 remote control units can be
programmed to function with the operator.
5.4.2 RADIO COURTESY LIGHT COMMAND (fig.27)
• Insert jumper JP1.
• Briefl y press button P1 twice.
switched ON for a moment then switched OFF for 1 second
and then ON again:
programming can begin.
• Press a button on the remote control you wish to program
((this button is used to switch ON the COURTESY LIGHT).
Warning light DL1 is switched OFF and the command is
programmed.
5.4.3 DELEING REMOTE CONTROL UNITS (fig.28)
Note: this operation deletes all previously programmed
remote control units.
• Remove jumper JP1.
• Press button P1 for approximately 10 seconds until warning
light DL1 is switched OFF.
6. MANUAL ELECTRIC DRIVE:
MANNED
Buttons P2 and P3 on the device are the MANUAL
CONTROLS to open and close the door (fi g.29).
!
Warning
The limit switches are not enabled in this mode!
Manned
functioning
Warning light DL1 is switched
Warning light DL1 is
P2 P3
OPEN CLOSE
Remote control
programming: START
3
Remote control programming:
COURTESY LIGHT
Twice
3
Deleting remote control units
10 sec.
- 22 -
JP1
1
DL1
P1
2
JP1
1
DL1
P1
2
JP1
1
DL1
P1
2
fig.26
fig.27
fig.28