Work; At The End Of The Work - Fimap FM 1500 S-V Manuel D'utilisation Et D'entretien

1.At this point, by pressing the man present push-button and activating the main switch control lever (1),
the machine can operate at full efficiency
2.Drive the machine with the disc rotating from left to right or in reverse
3.Immediately afterwards, drive the machine in a similar way but in reverse, so that about one quarter of
the working width overlaps the previous one
At the end of the work, and before carrying out any type of maintenance, perform the following
operations:
1.Disconnect the plug from the mains socket
2.Wrap it onto the rear brackets
3.Operate the handlebar adjustment lever (1) and set the column at rest
4.Move the machine indoors, in an area where it cannot cause any damage to people or surrounding
property, but where it can also be protected against the accidental fall of objects. In addition, do not park
the machine in open places or on sloping floors
5.Remove the pad (for brush removal refer to the section 'PAD REMOVAL' below)
WARNING: you are advised to always
wear protective gloves, to avoid the risk of
serious injury to your hands
SUCTION BAG ASSEMBLY (V VERSIONS)
6.Lift the bag cover (1) up
7.Take the collection bag (2) out of the suction coupling (3) having care not to damage the
cardboard support of the bag and to prevent dirt inside of the bag from coming out.
8.Refit the new collection bag and the cover making sure that the bag is completely inside
without being squashed by the cover's rims

WORK

AT THE END OF WORK
27