Installation; Preparation; Mounting The Legs; Fitting The Latch Button - Dovre 40CBS Installation Et Mode D'emploi

The base plate is grooved. The ashes that accu-
mulate in the grooves act as an insulating layer to
protect the base plate.

Installation

Preparation

Please check the appliance for damage caused dur-
ing transport or any damage or defects immediately
after delivery.
If you detect transport damage or any other
damage or defects, do not use the appliance
and notify the supplier.
Remove the removable parts (the cast-iron inner
plates) from the appliance before you start
installing the appliance. The door can also easily
be removed.
By removing removable parts, it is easier to
move the appliance and to avoid damage.
Note the location of the removable parts, so
that you can re-position the parts in the correct
place later on.
1. Open the door and unhook it from the appliance.
2. Remove the cast-iron inner plates.
Cast iron inner plates protect the combustion
chamber and dissipate heat to the sur-
roundings.

Mounting the legs

Fit the legs to the appliance; see the following figure.
Subject to change because of technical improvements
1. Using the bolts supplied M6, fit the two parts of
the legs to the desired height.
2. Tilt the stove on its back.
3. Fit the four legs on the bottom plate using the
washers and the M8 nuts that are found on the bot-
tom plate.

Fitting the latch button

Fit the button on the latch using the attachment mater-
ials included in the delivery; see the figure below.
Preparing the connection to
the flue
When connecting the appliance to the chimney you
have the choice of connecting via either the side, the
09-20001-034
9