Fog And Mist; Problems; Maintenance; Chimney - Dovre 525CB Mode D'emploi Et Installation

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

However, the air supply through the bottom of the fire
compartment must not be impeded and no ash should
be allowed to accumulate behind a cast iron inner
plate. Therefore, remove any excess ash frequently.
3
1
2
1. Open the door of the appliance.
2. Use the scraper to open the ash removal port in
the bottom of the fire compartment (1).
3. Using the scraper, sweep the excess ash (2)
through the ash removal port into the ashtray
underneath.
4. Close the ash removal port.
5. Remove the ashtray (3) using the glove provided
and empty the ashtray.
6. Install the ashtray and close the appliance door.

Fog and mist

Fog and mist hinder the flow of flue gases through the
flue. Smoke can blow back and cause a stench. If it is
not strictly necessary, it is better not to use the stove
in foggy and misty weather.

problems

Refer to the appendix "Diagnostic diagram" to
solve any problems in using the appliance.
Subject to change because of technical improvements

Maintenance

If the appliance does not give off enough heat:
Refer to the appendix "Diagnostic diagram" and
also check whether you are burning enough fuel.
Maintenance
Follow the maintenance instructions in this chapter to
keep the appliance in good condition.

Chimney

In many countries, people are legally required to have
their chimney checked and maintained.
At the beginning of the heating season: have the
chimney swept by an expert.
During the heating season and after the chimney
has not been used for a long time: have the
chimney checked for soot deposits.
After the heating season: seal off the chimney with
09-20008-009
a ball of paper.
Cleaning and other regular
maintenance activities
Do not clean the appliance when it is still
warm.
Clean the exterior of the appliance with a dry lint-
free cloth.
At the end of the heating season, you can clean the
interior of the appliance thoroughly:
If necessary, first remove the fire-resistant inner
plates. See the chapter "Installation" for
instructions on removing and installing the inner
plates.
If necessary, clean the air supply ducts.
Remove the baffle plate at the top of the appliance
and clean it.
Checking fire-resistant inner plates
The fire-resistant inner plates are consumables and
subject to wear . Check the fire-resistant inner plates
frequently and replace them when necessary.
11

Publicité

Table des Matières
loading

Table des Matières