Spare Parts 525Cb - Dovre 525CB Mode D'emploi Et Installation

See the chapter "Installation" for instructions on
removing and installing the inner plates.
The insulating vermiculite inner plates may
develop hairline cracks, but that does not
affect their performance adversely.
Cast-iron inner plates go a long way if you
frequently remove the ash that may pile up
behind them. If accumulated ash behind a
cast-iron plate is not removed, the plate cannot
dissipate the heat anymore to its surroundings
and that may cause the plate to warp or crack.
Never use the appliance without the fire-
resistant inner plates.
Cleaning glass
Dirt clings less easily to well-cleaned glass. Proceed
as follows:
1. Remove dust and loose soot with a dry cloth.
2. Clean the glass with stove window cleaner:
a. Apply stove window cleaner to a kitchen
sponge, rub down the entire glass surface and
give the cleaning agent time to react.
b. Remove the dirt with a moist cloth or kitchen
tissue.
3. Clean the glass again with a normal glass cleaning
product.
4. Rub the glass clean with a dry cloth or kitchen
tissue.
Do not use abrasive or aggressive products to
clean the glass.
Wear household gloves to protect your hands.
If the glass in the appliance is broken or
cracked, it must be replaced before you can
use the appliance again.
Make sure that no stove window cleaner runs
between the glass and the cast-iron door.
Lubrication
Although cast-iron is slightly self-lubricating, you will
still have to lubricate moving parts frequently.
12
Use
Lubricate the moving parts (such as hinge pins,
latches and air slides) with heat resistant grease
that is available in the specialist trade.
Touching up the finish
Small areas of damaged paint finish can be touched
up with a spraying can of special heat-resistant paint
finish available from your supplier.
Checking the seal
Check whether the sealing rope of the door is still
in good condition and works well. The sealing rope
is subject to wear and needs to be replaced in time.
Check the appliance for air leaks. Close any
chinks with stove sealant.
Let the sealant harden fully before you start a
fire in the appliance, because otherwise any
moisture in the sealant will form bubbles in the
sealant and cause a new air leak.

Spare parts 525CB

5
3
4
2
6
1
7
Pos. Description
1 03.66536.002 bottom of the fire
2 03.05404.002 ash removal port
3 03.77506.000 back inner plate on the
4 03.77504.100 inner plate on the
5 03.77505.000 baffle plate
6 03.77411.002 fire basket
Subject to change because of technical improvements
3
4
09-20008-004
Description
compartment
left and right
left and right side
Quantity
1
1
2
2
1
1