Installation; General Preparation - Dovre 525CB Mode D'emploi Et Installation

Installation

General preparation

Please check the appliance for damage caused
during transport or any other damage or defects
immediately after delivery. The appliance is
attached to the pallet with screws at the bottom.
If you detect damage caused during transport
or any other damage or defects, do not use the
appliance and notify the supplier.
Remove the removable parts (fire-resistant inner
plates, fire grate, top plate, ashtray) from the
appliance before you start installing the appliance.
By removing removable parts, it is easier to
move the appliance and to avoid damage.
Note the location of those removable parts, so
that you have no difficulties in installing the
parts in the right place later on.
1. Open the door; see the following figure.
6
Installation
2. Remove the fire-resistant inner plates; see the
2
3
1
09-20008-003
1
2
3
4
5
6
7
Connecting to the rear
1. Apply supplied fibre glass sealing tape (2)
2. Remove the protection plate from the back shield
09-20008-002
following figure.
a. Remove the fire basket (6).
b. Raise the baffle plate (5) at the front, pull the
baffle plate 2 cm forwards and allow the baffle
plate to drop down at the back
c. Remove the inner plates on the left and right
sides (4).
d. Remove the inner plates on the back (3).
Vermiculite inner plates are light and tend
to be ochrous in colour when delivered.
They insulate the combustion chamber to
boost combustion. Cast iron inner plates
protect the combustion chamber and
dissipate heat to the environment.
5
3
4
2
6
1
7
Removable internal sections
bottom of the fire compartment
ash removal port
back inner plate on the left and right
inner plate on the left and right side
baffle plate
fire basket
ashtray
measuring 10 x 3 mm to the contact surface of the
connection collar (8).
with the assistance of a screwdriver; see following
figure.
Subject to change because of technical improvements
3
4
09-20008-004