Technical Description - Satelec Acteon IMPLANT CENTER 2 Manuel D'utilisation

- a grounded power cord (Fig. 1-5),
- an LCD (Liquid Crystal Display) touch screen (Fig. 1-
6),
- a motor cord connector (Fig. 1-7),
- two peristaltic pump housings (Fig. 1-8),
- a cord connector for the two ultrasonic functions
(Fig. 1-9),
- a N L scaler cord (Fig. 1-10),
EWTRON ED
- a N L handpiece or a P
EWTRON ED
handpiece with its cord (Fig. 1-11) (according to
option).
Located at the back of the unit are:
- 1 power cord socket with ground pin (Fig. 2-1),
- 1 footswitch connector (Fig. 2-2),
- 1 fan (Fig. 2-3),
- 2 bracket holders (Fig. 2-4),
- 1 power switch (Fig. 2-5).
- 1 potential equalization connector (Fig. 2-6)

3. 2 TECHNICAL DESCRIPTION

a) LCD touch screen
The LCD touch screen (Fig. 3) is used to define the
settings of your I
MPLANT
The I C 2 is adjusted by applying moderate
MPLANT ENTER
pressure to the screen keys.
Identification of key areas common to all modes (Fig.
3):
- 4: Reduce irrigation flow rate.
- 5: Increase irrigation flow rate.
- 6: Reduce value.
- 7: Increase value.
Identification of information display areas common to
all modes (Fig. 3)
- 2: Irrigation flow rate value.
- 9: Operating fault indicator.
Identification of key areas common to all modes that
also display information (Fig. 3)
- 1: Flush/prime.
- 3: Irrigation ON/OFF.
IEZOTOME
C 2.
ENTER
- 8: Save, store data.
- 10: Select footswitch mode.
- 11: ON/OFF of light function on handpiece
- 12: Select mode (according to connected handpiece
type).
Key areas and displays specific to the selected mode
2 L P mode:
ED IEZOTOME
Identification of information display areas (Fig. 4)
- 13: Selected program power level.
Identification of key areas that also display
information (Fig. 4)
- 14: Select program: D1, D2, D3, D4.
N mode:
EWTRON
Identification of information display areas (Fig. 5)
- 15: Selected program power level.
Identification of key areas that also display
information (Fig. 5)
- 16: Select program: Soft, Medium, High, Boost.
I-S mode:
URGE
Identification of information display areas (Fig. 6)
- 17: Contra-angle ratio.
- 18: Motor speed value.
- 19: Motor delivered torque value.
Identification of key areas (Fig. 6)
- 20: Adjust contra-angle ratio.
- 21: Adjust motor speed.
- 22: Adjust motor delivered torque.
Identification of key areas that also display
information (Fig. 6)
- 23: Select micro-motor rotation (clockwise or
counterclockwise).
- 24: Select program: P1, P2, P3, P4.
7