Satelec Acteon IMPLANT CENTER 2 Manuel D'utilisation page 8

Contra-angle, speed
adjustment page
Identification of common information display areas
(Fig. 7)
- 25: Contra-angle ratio.
- 26: Maximum delivered speed.
- 27: Maximum delivered torque.
Identification of common key areas (Fig. 7)
- 28: Exit from the page without changes.
- 29: Delete last character entered.
- 30: Return to main page and save settings to screen
memory.
- 31: Numeric keypad.
Preprogrammed contra-angle adjustment page
Identification of information display areas (Fig. 8)
- 38: Contra-angle ratio.
- 39: Motor speed value.
- 40: Motor delivered torque value.
Identification of key areas (Fig. 8)
- 32: Exit from the page without changes.
- 33: Select custom contra-angle.
- 34: Return to main page and save settings to screen
memory.
Identification of key areas that also display
information (Fig. 8)
- 35: Select a multiplier contra-angle.
- 36: Select direct contra-angle.
- 37: Select a divider contra-angle.
Startup page
Identification of key areas (Fig. 9)
- 41: Enter T mode.
OOLBOX
Toolbox
Identification of information display areas (Fig. 10)
- 43: Audio volume symbol.
- 44: Screen brightness symbol.
- 45: Light off time-out symbol.
- 48: Relative audio volume value.
- 49: Relative brightness level value.
- 50: Selected time-out value.
8
and torque setting - 51: Software version.
Identification of key areas (Fig. 10)
- 42: Reset factory configuration.
- 46: Reduce value.
- 47: Increase value.
- 52: Validate the configuration.
b) Control unit back panel
The power receptacle (Fig. 2-1) with its grounding
pin is used to connect the I
power supply using a plug-in power cord.
The footswitch connector (Fig. 2-2) is used to
connect the I
MPLANT
control footswitch.
The fan (Fig. 2-3) protected by a metal grille, keeps
the I C 2 at its optimal performance level.
MPLANT ENTER
The bracket holders (Fig. 2-4) are used to install the
brackets.
The power switch (Fig. 2-5) is used to switch the
device ON or OFF.
The potential equalization connector (Fig. 2-6)
allows, if necessary, to connect devices together.
c) Control unit sides
The pump housings (Fig. 1-8) are designed to
accommodate SATELEC irrigation line cassettes.
The irrigation cassettes are installed by lifting the
pump covers and inserting the cassettes horizontally
into the cassette housings.
d) Front panel
- The left connector is designed to accept the
connector of the I-S
a SATELEC micro-motor cord must be used.
- The right-hand connector is designed to accept the
connector of the N
EWTRON
of the P 2 L
IEZOTOME ED
C
MPLANT ENTER
C 2 to the multifunction
ENTER
L micro-motor cord. Only
URGE ED
L cord or the connector
ED
handpiece cord.
2 to the