Description; Physical Description; Technical Description - Satelec Mini LED Black Manuel D'utilisation

Unit operation
Do not use the unit if it appears to be damaged or
defective.
Do not use the unit if the light guide is damaged (injury
hazard...).
Do not change the batteries during use.
Do not short-circuit the batteries.
Do not incinerate the batteries (risk of explosion).
Environment
Do not immerse and do not use outdoors.
Do not place the unit close to a heat source.
The use of solvents, detergents or flammable
substances can result in damage or even short-circuits.
In the event that the unit is not in use or stored, or in
the case of a prolonged absence, remove the batteries
from the device in order prevent their leakage.
The unit must be stored in its original packaging, in an
appropriate place, without danger for humans.
To transport the unit, remove the batteries and protect
the light guide from any unexpected shocks.
Any condensation inside electrical equipment can be
dangerous.
If the lamp must be transported from a cold place to a
warm place, it must not be used immediately, but only
after reaching the ambient temperature.
Never insert or try to insert metallic objects into the
equipment to avoid an electric shock or risk of short-
circuiting.
The unit is not designed for operation in the presence of
anesthetic gas or any other flammable gas.
Do not expose the unit to water mist or splashes.
The unit is not designed for operation close to ionizing
radiation.
Maintenance
Before and after each use, it is essential that the unit
be disinfected with the products recommended by
SATELEC.
Before each use, it is essential that a cleaned and
disinfected rigid protection shield be used.
Before each intervention, it is essential that a cleaned,
disinfected and sterilized light guide be used.
Before each intervention, check the integrity of the unit
and its accessories.
Accessories
Do not use accessories other than those supplied by
SATELEC.
The manufacturer refuses to accept any liability for
damaged parts or accessories unless they are replaced
exclusively by those supplied by the manufacturer. In
particular, the use of light guides or batteries of a type
other than that specified may be dangerous for the
patient and the user.
Repair
Do not perform equipment repairs or modifications
without the prior authorization of SATELEC.
In the event of an anomaly, remove the batteries from
the device and ensure that the lamp is not used before
being checked by the manufacturer or the supplier. This
anomaly may be due to noncompliance with safety rules
or because of technical damage to the unit.
In the event of an anomaly, contact the supplier of the
unit rather than an unauthorized repairer, who may
return your unit in a hazardous state for both you and
your patients.
www.acteongroup.com
Email: satelec@acteongroup.com
III – DESCRIPTION

3.1 PHYSICAL DESCRIPTION

The Mini LED Black includes the following components:
- Multi-fiber light guide, Ø 7.5 mm, sterilizable (1).
- A protective cap (2)
- The rigid protection shield (3).
- The Handpiece (6).
- Rear cover of the battery compartment (7).
- Accompanying literature.
Optional:
Kit of 5 sterilizable flexible optical shields Ø5.5mm (8)

3.2 TECHNICAL DESCRIPTION

The Mini LED Black is equipped with a Light-Emitting
Diode (LED) that emits visible blue light of a wavelength
between 420 and 480 nm for the photopolymerization of
dental materials.
The handpiece of the Mini LED Black comprises, from
top to bottom:
- The insertion window for the optical tip
- A shoulder to clip on the protection shield
- An operating indicator light
- The on/off button
- The cover for the battery compartment
Control button (5)
This is used to start the polymerization cycle. During
6