Optional Front Frame Kit; Central Filler Frame (Optional); Putting Appliance In; Fitting The Telescopic Pipe - Palazzetti ECOPALEX 64 Notice D'installation

Masquer les pouces Voir aussi pour ECOPALEX 64:
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

6.7 OPTIONAL FRONT FRAME KIT

Front frame kit, used to fix and blend Appliance in with
the structure of the fireplace where it is recessed in.
During the preinstallation phase, it will be necessary to
first fix the profiles on the side edges and upper edge
of the Appliance using the relative screws (Fig. 5.6: A
plugs - B Air outlet collars - C Front frame supports).
If you are not going to use the front filler frame, leave a
gap of at least 1 cm for air to circulate.

6.8 CENTRAL FILLER FRAME (OPTIONAL)

Measure the side panels and the front panel. If
necessary remove them with shears; fix them to the
profiles attached previously to Appliance (Fig. 5.6.1)
with the relative screws. If you are not going to use the
front filler fame leave a gap of at least 1 cm for air to
circulate.
The slits under the ash box or on the side must never be
obstructed so as not to undermine combustion efficiency.

6.9 PUTTING APPLIANCE IN

Before anything else, stand the Appliance on the
fireplace level. Spread a line of fire-sealant paste (that
resists a temperature of 800°C) on the bottom of the
collar (at the top). Move the fireplace into the final
position. You can make it easier to move by using two
2-3 mm thick metal sheet guides under it, removing
them once the fireplace is positioned (Fig. 5.7).

6.10 FITTING THE TELESCOPIC PIPE

This is the case when you are installing the Appliance
in an existing fireplace.
You first of all have to open the door, remove the
cast iron smoke diaphragm (Fig. 5.8.1) and pull it out
downwards. Remove the smoke butterfly regulator
diaphragm, lifting it first on the right and then pulling
it out from the left bush. Now, with one hand, pull the
rod fixed in the telescopic pipe downwards and put it in
place. Lastly, remove any excess
and put the butterfly diaphragm back in place as well
as the cast iron smoke diaphragm. The smoke fitting is
now installed.
ealant from inside
004770152 - 12/04/2021
Fig. 5.6.1
Fig. 5.7
Fig. 5.8.1
43

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Ecopalex 66Ecopalex 70Ecopalex 76Ecopalex 78Ecopalex 88

Table des Matières