Operator Safety Instructions; Inspections And Maintenance - Güde GSS 700P Mode D'emploi Original

6.1

Operator Safety Instructions

Unplug the unit before any maintenance/adjustment and repair. Unplug after finishing the work as
well.
•
Do not use the unit before you have read the operating manual carefully.
•
Observe all the safety instructions indicated in the manual.
•
Be responsible to the others.
6.2 Step by Step Instructions
•
Turn the slide with a clamping hole to the required position according to the saw disc diameter. .
•
Choose a suitable clamping adaptor and fix the disc in place.
•
Set up the slide so that it is not possible to sharpen the disc mistakenly when there is a hit on the
horizontal hole.
•
Mark the teeth internal surfaces with a black pen and put the grinding wheel in the standstill on the area
to be ground.
•
Switch the sharpening machine and scrape the surface marked in black off to enable additional
calibration.
•
Grind very carefully, according to the saw disc diameter, one tooth after another.
•
When grinding of all inner teeth areas are finished, grind evenly the teeth slopes on the inclined area of
the disc using a stop to provide for eccentric run of the disc.
•
Clean the unit carefully.
7 Troubles-Causes- Troubleshooting
Caution: Always check the overheating protection first!
Trouble Cause
1. The sharpening surface excessively
Burning disc (blunt)
2. Worn diamond layer.
7.1.1

Inspections and Maintenance

Unplug the unit before any maintenance/adjustment and cleaning. Unplug upon finishing the work as
well Keep the machine clean and free of any dust. Oil the slide well to prevent jerking.
lubricated.
Troubleshooting
1. Clean the unit with the sharpening tool.
2. Replace the disc
26