Güde GSS 700P Mode D'emploi Original page 22

Fig. 7
a
Fig. 8
Fig. 9
Fig. 9A
A stop needle should be mounted on to avoid
grinding the saw disc. It should be calibrated and
locked in place with a socket wrench.
Teeth are marked with the selector pen which
makes the removal well recognisable and
controllable
If the grinding wheel angle is set up in the way
providing for even grinding of the inner surfaces
of the teeth, the disc may be worked tooth by
tooth.
Caution
: Always take the saw disc beck
completely and avoid any jerky movements that
could damage the grinding wheel.
The inclined front side of the grinding wheel is
used to sharpen roof-like cutting edges. The
angles should be determined and set up in an
appropriated way. In this case too, use the stop
pike to observe the final even diameter of the saw
disc.
Caution: To make turn of the tool slide in the
position correct for grinding roof-like cutting
edges, it is necessary to turn the stop needle to
the motor side. (Fig. 9A)
To do that, socket screw should be loosened up
(Fig. 9A-A) and the stop needle turned on the side
of motor.
24