General Safety Instructions - Güde GSS 700P Mode D'emploi Original

1.2 Warranty
A warranty period of 12 months applies to commercial use and 24 months apply to private use and
commences on the day of purchase of the device.
Warranty applies exclusively to failures due to defective material or workmanship. An original sale slip with
indication of date of sale must be presented in case of claiming for the warranty rights.
Warranty does not cover unprofessional use such as device overload, violent use, damage caused by third
party or foreign materials, failure to comply with operations and assembly manual, and normal wear and tear.
2

General Safety Instructions

Prior to the initial use of the unit, the operating instructions should be read completely. If in doubt with regard
to connection and operation of the unit, consult the manufacturer (servicing department).
FOLLOW THE INSTRUCTIONS BELOW CAREFULLY IN ORDER TO SECURE A HIGH DEGREE OF
SAFETY:
Caution!
•
The unit should be safely attached to the bench horizontally.
•
Your work place should be kept clean and sufficiently lit (500 lux).
•
Never use the unit close to flammable materials, gases and liquids.
•
Wear protection goggles, ear protectors and suitable protection clothing. Use a respirator if necessary.
•
Wear clothes fitted to the occasion. Do not wear loose clothing or jewels that could be caught by rotating parts. Non-
skid shoes are recommended. If your hair is long, wear a hairnet.
•
Mind a stable poise and good footing when working with the unit.
•
Other persons, children in particular, should be kept away from the work site.
•
Always leave the existing protection equipment in place and make sure that they work perfectly. The operation
without the protection equipment is not allowed.
•
Make regular checks to see that all the screwed joint are fitted firmly.
•
Make sure that the power supply cable is not taken within the reach of rotating parts.
•
Do not leave the unit unattended if it is running. Any time you leave the unit, switch it off. Do no leave any
adjustment wrenches stuck in the unit. Before switching on, make sure that all the wrenches and adjusting tools are
removed.
•
Any longer products should be supported.
•
Avoid any contact with grinding aids and materials.
•
•
Be careful to avoid any hit on the saw disc. No warranty may be granted against the diamond disc damage.
The unit is allowed for use in FI mains (stray current protection)
17