Scope Of Use; Assembly And Starting - Stanley D 210/8/6 Manuel Utilisateur

OFF position and then to ON again (fig. 11-12).
● On certain «V» type versions, the reset button on the
G
terminal box of the motor must be pressed (fig. 13).
B
● On three-phase versions, simply return the button of
the pressure switch to the ON position. (fig. 12).
● Single-phase versions are fitted with a pressure
switch equipped with a delayed closing air discharge
valve which facilitates start-up of the motor. Therefore
venting of air from this valve for a few seconds with
the receiver empty is normal.
2. LAYOUT
1. Intake air filter
2. Pressure vessel
3. Wheel
4. Supporting foot
5. Quick-lock coupling (regulated compressed air)
6. Pressure gauge (for reading the preset tank pressure)
7. Pressure regulator
8. ON/OFF switch
9. Transportation handle
10. Safety valve
11. Receiver condensation drainage tap
12. Pressure gauge (for reading the tank pressure)
13. Quick-lock coupling (unregulated compressed air)
14. Oil dipstick (oil filler opening)
15. Oil drainage screw
16. Axle
17. Clip
18. Bolt
19. Nut
20. Washer

3. SCOPE OF USE

The compressor is designed for generating com-
pressed air for tools operated by compressed air.
Please note that our equipment has not been designed
for use in commercial, trade or industrial applications.
Our warranty will be voided if the machine is used in
commercial, trade or industrial businesses or for equiv-
alent purposes.
The machine is to be used only for its prescribed pur-
pose. Any other use is deemed to be a case of misuse.
The user / operator and not the manufacturer will be
liable for any damage or injuries of any kind caused as
a result of this.
● All the compressors are fitted with a safety valve
that is tripped in the case of malfunctioning of the
pressure switch in order to assure machine safety.
● When fitting a tool, the flow of air in output must be
switched off.
● When using compressed air, you must know and
comply with the safety precautions to be adopted for
each type of application (inflation, pneumatic tools,
painting, washing with water-based detergents only,
etc.).
4. POINTS TO NOTE WHEN SETTING
UP THE COMPRESSOR
● Examine the machine for signs of transit damage.
Report any damage immediately to the company
which delivered the compressor.
● The compressor should be set up near the working
consumer.
● Avoid long air lines and long supply lines (extensions).
● Make sure the intake air is dry and dust-free.
● Do not set up the compressor in damp or wet rooms.
● The compressor may only be used in suitable
rooms (with good ventilation and an ambient tem-
perature from +5°C to +40°C). There must be no
dust, acids, vapors, explosive gases or inflammable
gases in the room.
● The compressor is designed to be used in dry
rooms. It is prohibited to use the compressor in
areas where work is conducted with sprayed water.
● The oil level in the compressor pump has to be
checked before putting the equipment into operation.

5. ASSEMBLY AND STARTING

Warning!
You must fully assemble the appliance before us-
ing it for the first time.
5.1 Fitting the wheels (Fig. 4 ÷ 5)
Fit the supplied wheels as shown in figures 4 & 5:
● Fig.4a & 4b: Assembly of wheel kit - version A
● Fig.5a & 5b: Assembly of wheel kit - version B
5.2 Fitting the supporting foot (ref. 4)
Fit the supplied rubber stopper as shown in Fig. 6.
5.3 Fitting the transport handle (only
for D 240/xx & D 260/xx)
Screw the transport handle (ref. 9) to the compressor
as shown in Figures 16 and 17.
22