Scope Of Use; Electrical Grounding Instructions; Start-Up Procedures; Cleaning And Maintenance - Stanley HY 227/10/5 Manuel Utilisateur

G. Safety valve:
adjust or eliminate this safety device.
Any adjustments to this valve could cause serious injury. If
this device requires service or maintenance, see an Authorized
H. Handle for lifting/moving
I. Wheel
J. Rubber foot.

3. SCOPE OF USE

The compressor is designed for generating compressed air for tools
Please note that our equipment has not been designed for use
be voided if the machine is used in commercial, trade or industrial
the manufacturer will be liable for any damage or injuries of any kind

4. ELECTRICAL GROUNDING INSTRUCTIONS

electrical short circuit, grounding reduces the risk of electrical shock by
with a cord having a grounding wire with an appropriate grounding
4.1 Connection of the mains plug
Important!
The wires in the mains lead fitted to this product are coloured in
If for any reason the 13 amp plug fitted to this product requires
replacement it must be wired in accordance with the following instruction:
Do not connect the brown (live) or blue (neutral) to the earth pin marked
'E' on the 3 pin plug.
insulation is gripped by the cord grip and that the wires are not trapped
If in doubt consult a qualified electrician
Warning!
For your protection if this product is to be used outdoors it should not
Note: If the mains cable requires replacing it must be replaced with
5. PRE-START PROCEDURES
Do not attempt to
prohibited to use the compressor in areas where work is conducted
5.3 Assembling the quick coupler
Tighten the quick coupler for regulated pressure to the coupling on the
6. OPERATING INSTRUCTIONS

6.1 Start-Up Procedures

will automatically cycle on and off to keep the tank pressure
6.2 Shut-Off Procedures
pneumatic tool, connected to the compressor through the quick

7. CLEANING AND MAINTENANCE

Warning!
Pull the power plug before doing any cleaning and maintenance
work on the appliance.
Warning!
Wait until the compressor has completely cooled down! Risk of
burns due to hot surfaces!
Warning!
Always depressurize the tank before carrying out any cleaning
and maintenance work.
7.1 Cleaning
the equipment with a clean cloth or blow it with compressed air at
7.2 Draining tank
The condensation water must be drained off each day by opening the
17
O
I
O
G
B