Hilti POS 15/18 Mode D'emploi page 50

10.2.5.1 Measuring to the first reference point
Corresponding coordinates or positions are searched for in the graphic data saved in the system.
If no point data exists under this name the coordinates have to be entered manually.
10.2.5.2 Measuring to the second reference point
Continue by checking the distance between the station and the orientation point, as described in the applicable
section.
10.2.5.3 Set station
The station is always saved in internal memory.
If the station name already exists in memory, the station must be renamed. i.e. a new name assigned to it.
Enter the name of the orientation
point.
Return to previous view.
Measure angle and distance.
Continue to "Measure to the
second reference point".
Return to "Measuring to the first
reference point".
Measure angle and distance.
Continue to "Set station".
Checking the distance between
reference points
For entering station names.
Return to orientation measure-
ment.
Show station data.
Setting the station.
en
45