Hilti POS 15/18 Mode D'emploi page 45

10.2.3.1 Measuring to the first reference point on a control line
en
10.2.3.2 Measuring to the second reference point
Continue by checking the distance between the station and the orientation point, as described in the applicable
section.
10.2.3.3 Set station
The station is set immediately after the angle measurement for orientation purposes.
NOTE
The station is always saved in internal memory. If the station name already exists in memory, the station must be
renamed. i.e. a new name assigned to it.
40
Enter the name of the orientation
point.
Return to previous view.
Measure angle and distance.
Continue to "Measure to the
second reference point".
Return to "Measuring to the first
reference point".
Measure angle and distance.
Continue to "Set station".
Checking the distance between
reference points
Alphanumerical field for entry of
station name.
Return to previous view.
Show station data.
Setting the station.