Touch Screen - Alphanumerical Keyboard; Touch Screen - General Operating Controls; Laser Pointer Status Indicator; Battery Condition Indicators - Hilti POS 15/18 Mode D'emploi

7.5.5 Touch screen – alphanumerical keyboard
When alphanumerical data is required to be entered, the appropriate keyboard appears in the display automatically.
The keyboard layout is as shown in the illustration below.
en
7.5.6 Touch screen – general operating controls

7.5.7 Laser pointer status indicator

The tool is equipped with a laser pointer.

7.5.8 Battery condition indicators

The tool uses 2 lithium-ion batteries which can supply power at the same time or one after the other, depending on
requirements.
The tool switches from one battery to the other automatically.
One of the batteries can thus be removed at any time, e.g. for charging, while continuing to use the tool with the other
battery - so long as its capacity allows.
NOTE
The state of battery charge is indicated by the extent to which the battery symbol is "filled".
22
Application button - used to start an application or function.
Button for direct entry of numerical data, including symbols and decimal
points.
Button for direct entry of alphanumerical characters, including upper and
lower cases.
Select from a list. These lists may contain numerical or alphanumerical
values and settings.
A drop-down menu. In most cases, these menus provide a maximum of
three options for the selection of settings.
Example of a button in the bottom line of the display.
Laser pointer ON
Laser pointer OFF
Cancel and return to previous
screen.
Switch to lower case letters.
Switch to numerical keys.
Confirm and apply the entry.
Move the cursor to the left.
Move the cursor to the right.
Delete the character to the left
of the cursor position. If there
is no character to the left, the
character at the cursor position
will be deleted.