Starting up
The chain counter features a graphic display and three keys:
(BOW LEFT),
(BOW RIGHT),
The ON key switches on the display and enables the other two keys. It must be used to access the
parameter setting menus. For selecting the parameters to be modified and to confirm the values set. The
display backlight will switch off 15 seconds after the last command given.
The UP key commands the hoisting of the anchor and the DOWN key casts it. When the key is released,
the action is stopped. During parameter setting, the two keys allow the User to move around the menu
and vary parameter values.
When switched on, the instrument will make a beep and the following page will appear for a few seconds:
Once the initialisation procedure is complete, the main page will appear.
COUNT
CHANGE OF MODE
SPEED
SUPPLY VOLTAGE
OF THE RECEIVER
Where:
STATUS: indicates the status of the instrument and any failure.
UNIT OF MEASURE: shows the current unit of measure (metres or feet)
ANIMATION: an animated anchor or capstan shows the direction of the movement.
COUNT: indicates the measurement of the chain lowered (in metres or feet).
CHANGE OF MODE: this icon is displayed when there is a change in working mode (windlass mode or
capstan mode)
SPEED: indicates the chain speed during hoisting or lowering in meters per minute (mt/m) or feet per
minute (ft/m)
SUPPLY VOLTAGE: indicates the power supply voltage of the receiver.
INTERNAL BATTERY LEVEL: indicates the state of charge of the internal battery of the remote control.
The icon immediately to its left indicates the charge in progress when the transmitter is placed on its
charging base.
WHC040
(STERN LEFT),
(BOW RIGHT)..
WHC040
CHAINCOUNTER
20
English
(ON),
(UP) and
STATUS BAR
UNIT OF MEASURE
ANIMATION
BATTERY LEVEL OF
THE TRANSMITTER
Rev. 02-2021
(DOWN) ,