MZ electronic WHC040 Instructions D'utilisation page 21

Radio compteur métrique
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

When the instrument is turned on for the first time, it will set up as programmed in the factory (see table).
Windlass / Capstan mode
HC020 chaincounter has two different operating modes: Windlass mode and capstan mode:
WINDLASS
When the device is turned on it is set in windlass mode, which is standard operating mode by default: it is
possible to operate the windlass obtaining lowered chain meters, chain speed and sensor error in case of
faults on the sensor installed on the windlass.
In capstan mode, capstan is put in motion for standard mooring operation, without sensor reading; this
way, the chain length doesn't change, chain speed is not displayed, and no sensor signal is given as it is
not used when the chain is not in motion.
In order to shift from one mode to the other one, you need to press the button
seconds to make the icon change mode appear:
Release the button
capstan and vice versa.
WHC040
Parameter
Up Alarm
Auto Down
BackLight Time
Units of measurement
Chain Measure
Barbotin Circumference
Sensor type
Language
Works Hours
Division factor
(ON) when the icon appears in order to do the mode change from windlass to
Default value
3.0 metres
Off
15 seconds
Metres/centimetres
0.0 metres
33 cm
Standard
Italian
0
1
21
English
CAPSTAN
(ON) for about 3
Rev. 02-2021

Publicité

Table des Matières
loading

Table des Matières