Useful Facts; Interfaces And Outputs - IKA ULTRA -TURRAX Tube Drive P control Mode D'emploi

• Range of use (indoor use only):
- Laboratories - Schools
- Pharmacies - Universities
The device is suitable for use in residential areas and all other areas.
The safety of the user cannot be guaranteed:
- If the device is operated with accessories that are not supplied or
recommended by the manufacturer
- If the device is operated improperly contrary to the manufacture's
specifications
- If the device is operated improperly contrary to the manufacturer's
specifications.
6

Useful facts

Changes in viscosity and volume caused by processing of disper-
sion media may cause small fluctuations in the speed of the device.
7

Interfaces and outputs

Remote control:
The device can be operated in "Remote" mode via USB interface us-
ing labworldsoft ® laboratory software. The USB interface is located
on the back side on the device and can be connected to a PC using
the USB cable.
Note: Please note the system requirements as well as the operating
instructions and help section included within the software.
USB Interface:
The Universal Serial Bus (USB) is a serial bus for connecting the
device to the PC. Equipped with USB devices can be connected to
a PC during operation (hot plugging). Connected devices and their
properties are automatically recognized. Use the USB interface in
conjunction with labworldsoft ® for operation in "Remote" mode
and also to update the firmware.
Installation:
First, download the latest driver for IKA devices with USB interface
from: http://www.ika.com/ika/lws/download/usb-driver.zip.
Install the driver by running the setup file. Then connect the
IKA device through the USB data cable to the PC. The data
communication is via a virtual COM port. Configuration, command
syntax and commands of the virtual COM ports are as described
in RS 232 interface.
Command syntax and format:
The following applies to the command set:
- Commands are generally sent from the computer (Master) to
the device (Slave).
- The device sends only at the computer's request. Even fault in-
dications cannot be sent spontaneously from the device to the
computer (automation system).
- Commands are transmitted in capital letters.
- Commands and parameters including successive parameters are
separated by at least one space (Code: hex 0x20).
- Each individual command (incl. parameters and data) and each
response are terminated with Blank CR LF (Code: hex 0x20 hex
0x0d hex 0x20 hex 0x0A) and have a maximum length of 80
characters.
- The decimal separator in a number is a dot (Code: hex 0x2E).
The above details correspond as far as possible to the recommen-
dations of the NAMUR working party (NAMUR recommendations
for the design of electrical plug connections for analogue and
digital signal transmission on individual items of laboratory control
equipment, rev. 2.9).
19