Set Menu Parameters; Operation Mode; Operation Language - IKA ULTRA -TURRAX Tube Drive P control Mode D'emploi

11 Setting menu parameters
11.1

Operation mode

The device can be operated in mode A, B and P1 to P9. The mode
setting will be stored automatically when operation is over, or the
device is switched off. User may change the mode setting in the
main menu if necessary.
• Operation mode A
In this mode, when current operation is over or the device is
switched off, all working settings will not be stored.
• Operation mode B
In this mode, when current operation is over or the device is
switched off, all menu and working settings will be stored.
• Operation mode P1 - P9
In mode P1-P9, the user can set and save required parameters,
(target speed, timer value and rev value) in program. The param-
eter settings can only be changed in the menu program. These
settings can also be used directly when necessary.
• Setting operation mode between A and B
 Press the "Menu/Back" button (C) in the main menu.
 Turn the "Rotating/Pressing" knob (B) to select the "mode" item
in the main menu.
 Press the "Rotating/Pressing" knob (B).
 Turn the "Rotating/Pressing" knob (B) to select mode A or B in
submenu.
 Press the "Rotating/Pressing" knob (B) again to complete the
process.
 Press the "Menu/Back" button (C) to return to the working screen.
• Setting operation mode between P1 and P9
 Press the "Menu/Back" button (C) in the main menu.
 Turn the "Rotating/Pressing" knob (B) to select the "mode"
item in the main menu.
 Press the "Rotating/Pressing" knob (B).
 Turn the "Rotating/Pressing" knob (B) to select the "mode"
item in mode P1 and P9 in submenu.
 Press the "Rotating/Pressing" knob (B) and enter desired
menu program.
 Turn the "Rotating/Pressing" knob (B) to select desired pro-
gram item.
 Press the "Rotating/Pressing" knob (B) .
 Turn the "Rotating/Pressing" knob (B) to change the value.
 Press the "Rotating/Pressing" knob (B) again to complete the
setting.
 Press the "Menu/back" button (C) to complete the process,
display will return to working screen.
Note: The target speed and timer value in the program should be
less than "rpm max" and "timer max" setting in menu. Otherwise,
the device will run according to the setting in the menu.
11.2

Operation language

The language can be set to: English, German, Chinese, French,
Spanish, Italian and Korean. The language setting will be stored au-
tomatically when operation is over or the device is switched off.
User can change the language setting in the main menu if necessary.
• Setting operation language
 Press the "Menu/Back" button (C) in the main menu.
 Turn the "Rotating/Pressing" knob (B) to select the "lan-
guage" item in the main menu.
 Press the "Rotating/Pressing" knob (B) to confirm "lan-
guage".
 Turn the "Rotating/Pressing" knob (B) to select a language.
 Press the "Rotating/Pressing" knob (B) again to complete
the setting.
 Press the "Menu/Back" button (C) to return to the working
screen.
22