Cleaning And Maintenance - Meister MFW12 Traduction Du Manuel D'utilisation Original

5454310-Akku-Multi_man 11.01.18 13:08 Seite 84
Scraping
To obtain good results, the
scraper (15) must be sharpened
regularly.
Choose a medium to high speed for
scraping.
Sanding
– Choose a high speed for sanding.
Observe the following instructions
for correct sanding:
– Move the multi-function tool
parallel and in a flat circle, or
alternating between lengthwise
and crosswise directions.
– Do not press the multi-function
tool down too hard. Added
pressure will not increase the
work performance.
– When sanding sections and
grooves, work with the tip alone, or
an edge of the sanding plate (13).
– Do not use the multi-function
tool with liquid polishing or
sanding materials.
– If only one corner is worn away,
move the sanding sheet (16) by
120°.
Charge level display
The multi-function tool has a 3-level
charge level display (7). It shows the
charge level of the battery (4).
84
LED Charging status
Green LED The battery is fully
charged.
Orange LED The battery has
enough power for
work, but must be
recharged after
finishing work.
Red LED The battery must be
charged.
10 – Cleaning and
maintenance
WARNING! Risk of injury!
Accidentally switching on the
multi-function tool may lead to
severe injury. Remove the battery
from the multi-function tool
before doing any cleaning or
maintenance work on the tool.
WARNING! Risk of burns!
Some tools become hot
during operation, and you may
burn yourself. Let the tool cool
down completely before carrying
out any cleaning work.
NOTICE! Risk of damage!
Improper use of the multi-
function tool can lead to damage
to the tool. Do not use any
aggressive cleaning agents,
brushes with metal or nylon
bristles, sharp or metallic
cleaning objects such as knives,
hard spatulas and similar objects.