Sinmag Europe AutoBun 3-52 Mode D'emploi page 25

MONTHLY
ENG
Remove the plate on the right side of the machine and check the oil level in the hydraulic
tank. The oil reservoir must be filled for 75%.
If not: fill the reservoir with hydraulic oil with a viscosity of 68#.
Take out the moulding table and check if mechanism is well greased.
The moulding table must be put back correctly. The slits in the base footing of the moulding
table have to fit upon the upper sliding faces of the side and the pin of the drive shaft has to
fit into the ball bearing of the moulding plate.
The best way to carry this out, is to attach the moulding table at the side and then lift one
side in order to check whether all parts have been positioned correcly.
Before assembling the moulding table, the slide has to be fitted in accordance with the
two red marks which are shown on the small cover sheet. Then the moulding table can be
inserted vertically from above in order that the driving pin and the parallel guide of the slide
fit in the corresponding holes and slits. After assembling the moulding table, check correct
position by letting the machine mould.
Every 3 months
Tightening of V-Belts should be done from time to time when machine slows down.
10