Auto Mode; Music Mode; Midi Operation; Midi Channel Setting - Nicols C 512 J Notice D'utilisation

Auto Mode

1. Tap the Auto/Del button to activate Auto mode. The Auto LED lights indicating Auto mode is active.
2. Select your desired chase by tapping one of the six Chase buttons. A second tap of this button will deactivate this function.
3. Use the Speed Time slider(or Tap Sync) and Fade Time slider to adjust the chase to your desired effects. You may select several
chases at a time, the chases will run in sequence that you select the chases.

Music Mode

1. Tap the Music/Bank Copy button to activate Music mode, the Music LED lights indicating Music mode is active.
2. Select your desired chase by tapping one of the six Chase buttons, the chase will be triggered by the music rhythms.
You may select several chases at a time.

MIDI OPERATION

MIDI Channel Setting

1. Press and hold down the MIDI/Rec button for three seconds, the LCD show the MIDI channel of last time.
2. Use the Bank Up/Down button to select the DMX channel 01-16 to assign to MIDI channel.
3. Press and hold down the MIDI/Rec button for three seconds to store your setting and to deactivate MIDI setting.
To cancel your setting, tap any other button (except Bank Up/Down buttons) to exit MIDI mode
SEND FILE TO DUMP
NOTE
You must set up proper connection before you can send or receive the file dump.
1. With the power off, press and hold down the Scanner buttons 2, 3 and Scene button 1 at a time.
2. Apply the power again while pressing these three buttons, the LCD shows "TRANSMIT" indicating this unit is ready to send the file
dump.
3. Press the Scene buttons 7 and 8 at a time to send the file dump.
4. If an error occurs during the file dump, the LCD will readout "ERROR"
Page 24