Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Bank copy
1.
Program enable. Press the BLACKOUT key to turn the LED off
2.
Tap the Bank Up/Down button to select the bank you wish to copy.
3.
Tap the MIDI/Rec button.
4.
Tap the Bank Up/Down button to select the bank you wish to copy to.
5.
Tap the Music/Bank Copy button, all LEDs will flash three times briefly indicating the function has been completed.
6.
Press the Program button for three seconds to exit Programming mode.
Programming Chase
You must program scenes before you can program chases, this function
allows you to store up to 240 scenes into one chase.
1.
Program enable. Press the BLACKOUT key to turn the LED off
2.
Tap the Chase button to select the chase to program. Each time you can select a chase only
3.
Select a desired scene from the bank that has stored scenes.(described in Programming Scenes)
4.
Tap the MIDI/Rec button.
5.
Repeat steps 3-4 until you've reached your desired effect.
You may record up to 240 scenes into a chase.
Programming a bank of scenes into a chase
1.
Program enable. Press the BLACKOUT key to turn the LED off
2.
Select the chase using CHASE buttons 1 to 6
3.
Use Bank Up/Down button to select the bank that contains the scenes you wish to copy.
4.
Tap the Music/Bank Copy button.
5.
Tap the MIDI/Rec Copy button, all LEDs will flash three times briefly indicating all 8 scenes in this bank have been
programmed into this chase.
CHASES
Page 19
Publicité
Table des Matières
