Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Rear View :
1. MIDI IN
DMX Polarity Select
2.
3. DMX Out
DMX In
4.
Fog Machine Connector This connector is used to plug in the Fog Machine.
5.
DC Input
6.
7. Power Switch
AUDIO IN
8.
OPERATION GUIDE
This unit allows you to program 12 scanners of 16 DMX channels, 30 banks of 8 programmable scenes, 6 chases of 240 programmed
scenes using 8 faders and other function buttons. With the use of two jog wheels, you may easily control the Pan or Tilt of the
scanners. To tailor your special effect lighting, this unit enables you to Assign or Reverse the DMX channels. In addition, two units can
set up communication so that they can send or receive file dump.
Display Information
The LCD Display contains a maximum of 2x8 characters.
LCD Display
Message
CHASE 5
Chase 5 is activated.
STEP 002
The 2nd step of a chase
DATA 151
DMX value(000-255)
SP: 1M36S
The current Speed Time is 1 minute and 36 seconds
TP: 5.32S
The time of the last two taps is 5.32 seconds
FT: 10.5S
Fade Time is 10.5 seconds
ASS 07 08
Assign DMX channels 7 and 8
RES 10 13
Reverse DMX Channels 10 and 13
SN 6
Scene 6
BK 03
Bank 03
Program Enable
When the power is turned on, this unit enters Manual mode automatically.
Press the Program button for three seconds to activate Program mode, the LED near to this button lights
indicating Program in active.
Receives MIDI data.
Used to select DMX polarity.
This connector sends your DMX value to the DMX scanner or DMX pack.
This connector accepts your DMX input signals.
DC 9 -12V, 500mA min.
This switch turns On/Off the power.
0.1V~1Vp-p.
Page 16
Publicité
Table des Matières
