Delete All Chases - Nicols C 512 J Notice D'utilisation

Console dmx 16 canaux
Masquer les pouces Voir aussi pour C 512 J:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Add a Step
1.
Program enable. Press the BLACKOUT key to turn the LED off
2.
Select the chase you wish to add a step to.
3.
Tap the Tap/Display button, the LCD shows the current step.
4.
Tap the Bank Up/Down button to scroll to the step you wish to add a step after.
5.
Tap the MIDI/Rec button, the Segment Display will read the step one higher than before.
For example, if you want to insert a step between step 3 and step 4, and you scroll to step 3, when you tap the MIDI/Rec button, the
LCD will read "STEP 004".
6.
Tap the Tap/Display button again, the LCD shows the current chase, scene and bank. Create a desired scene and record it
as a new step or select a programmed scene you wish to add into this chase.
Hints: You may tap the Tap Sync/Display button to change the display mode between step and the bank.
7.
Tap the MIDI/Rec button again , all LEDs will flash three times briefly indicating the new step has been inserted into this
chase.
Delete a Step
1.
Program enable. Press the BLACKOUT key to turn the LED off
2.
Select the chase that contains the step you wish to delete.
3.
Tap the Tap/Display button, the LCD shows the current step.
4. Tap the Bank Up/Down button to scroll to the step you wish to delete.
5. Tap the Auto/Del button to delete the step, all LEDs will flash three times briefly indicating that the step has been deleted.
Delete a chase
1. Select the chase you wish to delete.
2. Press and hold down the Auto/Del button. Tap the Chase button while holding down the Auto/Del button, all LEDs will flash three
times briefly indicating this chase has been deleted.

Delete all chases

1. With the power off, press and hold down the Auto/Del and Bank Down buttons at the same time.
2. Apply the power again.
Page 20

Publicité

Table des Matières
loading

Table des Matières