Auto Mode; Slave Mode - Nicols LED STROB 3 Manuel D'utilisation

Cool white
Built-in programs, sound active, M/S mode, DMX mode, static colors
DMX channels: 7 channels.
Very compact design
3. Operation of the unit
3.1 Built-in programs modes
Press MODE button. Enter built-in program mode menu "Pro". Press SETUP button , enter
running program segment menu "Pr.×".Press UP or DOWN button , setup effect program
segment "Pr. 1 ～ Pr.4".Press SETUP button , enter program run speed setup menu
"SP.×".Press UP or DOWN button. Set up speed value "SP.1～SP.9".

3.2 Auto mode

Press MODE button. Enter auto run built-in program menu "AUT". Press SETUP button.
Enter setup program run speed menu "SP.×". Press UP or DOWN button. Setup speed value
"SP.1～SP.9". Press SETUP button. Enter setup single segment program run times menu
"n._×".Press UP or DOWN button. Set up single segment program run times "n._1～n._9".
3.3 Sound active mode 1
Press MODE button, enter sound active mode 1 "Sd1".Rotate potentiometer to adjust the
sensitivity of sound active: if you rotate the potentiometer clockwise, the sensitivity will be
high. If you rotate the potentiometer counterclockwise the sensitivity will be low.
On this mode, external noise strike one time, this light will be carried out single –step sound
active effect. Within 5 seconds there is no sound, the light will be automatic quench.
3.4 Sound active mode 2
Press MODE button to enter sound active run mode 2 "Sd2". Rotate potentiometer to adjust
the sensitivity of sound active: if you rotate the potentiometer clockwise, the sensitivity will be
high. If you rotate the potentiometer counterclockwise the sensitivity will be low.
On this mode, external sound trigger one time, the light will be flicker one time, add the sound
in more, the flicker times will be increase.

3.5 Slave mode

Press MODE button. Enter slave running mode "SLA".
4-