Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Programming scenes
1.
Enter Program mode. Press the BLACKOUT key to turn the LED off.
2.
Press the Scanner button to turn on its fader control, which is indicated by the lit LED.
You may select several scanners at a time by tapping of these Scanner buttons, so you can set several scanners at a time.
3.
Move the faders to select your desired dimmer intensity if you are using a dimmer.
You can also use the two jog wheels to control the Pan or Tilt movement of the scanner.
4.
If necessary, you may tap the Page Select button to control the second set of 8 DMX channels.
5.
Once the scene is satisfactory, tap the MIDI/Rec button to program this scene into memory.
6.
Tap the Bank Up/Down button to select the bank you want to store your scene into. There are total 30 banks you can select,
you may store up to 8 scenes into each bank.
7.
Tap the Scene button to store your scene, all LEDs and the Segment Display will flash three times briefly indicating this
operation, then the LCD will show the bank and the scene
8.
Repeat steps 3-7until all desired scenes have been programmed into memory .Tap the Scanner button again to turn off its
fader control.To set another scanner(scanner), you may tap the corresponding Scanner button to turn on its fader control,
then you may begin your programming again.
9.
If you don't intend to continue your programming, press and hold down the Program button for three seconds to exit Program
mode, the LED goes out indicating this selection.
EXAMPLE: Program 8 scenes with channel 1-8 at full in sequence into bank 3 and assign these scenes to scanner 1.
1. Program enable. Press the BLACKOUT key to turn the LED off.
2. Tap the Scanner 1 button to turn on its fader control.
3. Tap the Page Select button to select Page A.
4. Push Fader 1 to the top position.
5. Tap the MIDI/Rec button.
6. Select bank 3 using Bank Up/Down button.
7. Tap the Scene 1 button to store the first scene.
8. Repeat steps 4-7 until all 8 scenes have been programmed into bank 3.
9. Tap the Scanner 1 button again to turn off its fader control.
10. Press the Program button for 3 seconds to exit Programming mode.
Scene editing
1.
Program enable. Press the BLACKOUT key to turn the LED off.
2.
Tap the Bank Up/Down button to select the bank that contains the scene you wish to edit.
3.
Select the scene you want to edit by tapping its Scene button.
4.
Use the Faders or jog wheels to make your desired adjustments.
5.
Once you've made your changes, tap the MIDI/Rec button
6.
Tap the Scene button that corresponds to the scene you're editing. This will overwrite the exited scene
NOTE:
Be sure to select the same scene in steps 3 and 6, otherwise you may accidentally record over an exited scene.
SCENES
Page 17
Publicité
Table des Matières
