Nicols C 512 J Notice D'utilisation page 23

Delete a scanner of DMX channels
1. Activate Assign or Reverse mode
2. Tap the Scanner button to select the scanner you wish to delete.
3. Press the Mode and Auto/Del buttons at a time,all LEDs should flash briefly, indicating the scanner is deleted.
Clear all DMX channels
1. Turn the power off.
2. Press the Mode and Auto/Del buttons at a time.
3. While pressing the two buttons, apply the power again, all LEDs should flash briefly, indicating all assigned
or reversed DMX channel are cleared.
Display DMX channels
1. Press the Fine and Mode buttons at a time,the Assign LED lights.
2. Press the Fine and Mode buttons the second time,the Assign LED goes out and the Reverse LED lights.
3. Tap the Scanner button that holds the Pan and Tilt channel, the LCD shows the Pan and Tilt.
1. With the power off, press the Mode and TAP/Display buttons at a time.
2. Apply the power again, tap the TAP/Display button to change between Fade Time and Assign Fade Time, the LCD reads
ALL CH
FD TIME
3. Press the Mode and TAP/Display buttons at a time to store your setting into memory. If you are not going to save your setting, tap
the Blackout button to leave this operation.
FADE TIME / ASSIGN FADE TIME
or ONLY X/Y
FD TIME
Page 22