Manual Mode
1. When the power is turned on, this unit enters Manual mode automatically. This function allows you to run a bank of programmed
scenes in a sequential loop.
2. Make sure Auto and Music LEDs are both off.
3.Use the Bank Up/Down button to select the bank that contains the scenes you wish to run.
4. Tap the Scene button to select the scene to run.
Auto Mode
This function allows you to run a bank of programmed scenes in a sequential loop.
1. Tap the Auto/Del button to activate Auto mode. The Auto LED lights indicating Auto mode is active.
2. Use the Bank Up/Down button to select a bank of scenes to run.
3. After selecting the bank of scenes you wish to run, you can use the Speed Time slider (or Tap Sync/Display button) and Fade Time
slider to adjust the scenes to your desired effect.
Hints:
The Tap Sync button is used to set the speed by tapping the button several times, the last two taps will define the speed with a
maximum of 5 minutes. Tap Sync will override any previous setting of the SpeedTime slider unless the slider is moved again.
4. Tap the Auto/Del button again to exit Auto mode .
Music Mode
1. Tap the Music/Bank Copy button to activate Music mode. The Music LED lights indicating Music mode is active.
2. Use the Bank Up/Down button to select the bank that holds the scenes you wish to run. The scenes you've selected will chase in a
sequential order according to the music rhythms detected by the built-in microphone.
3. Tap the Music/Bank Copy button again to exit Music mode.
You must program scenes before you can run chases.
Manual Mode
1. When the power is turned on, this unit enters Manual mode automatically.
2. Select your desired chase by tapping one of the six Chase buttons. A second tap of this button will deactivate this function.
3. Use the Fade Time slider to adjust the current scenes to your desired effects.
4. Use the Bank Up/Down button to run the chase step by step.
RUNNING SCENES
RUNNING CHASES
Page 23