SKYLOTEC GET UP Instructions D'utilisation page 14

Figure 4 : MIXED PROGRESSION
Never exceed the height of the rope clamp with the
attachment point of your harness (always keep the
fall factor < 1). Because of a danger of a fall a 10 mm
or thicker rope must be used.
Figure 5 : HORIZONTAL PROGRESSION
As shown in figure 5. In working environments
redundancy in safety systems is compulsory.
Figure 6 : HAULING SYSTEMS
There are many variants of hauling systems possible.
Work always with the load secured against falling
and no slack in the line.
General information
Regular examination
• Do not hesitate to retire the device if it shows signs
of wear or after a major fall or a major impact. They
could cause internal or invisible damage that may
significantly weaken its strength. In case of
uncertainty treat the device as damaged or consult
SKYLOTEC.
• Regular periodical inspections should be carried
out by a competent person at least once a year. For
this purpose an inspection record should be
established (see the backside of these instructions).
Furthermore we would sincerely recommend one set
of equipment is used by one person only as its
history of use is best traced and understood in this
way.
• Before each use it is obligatory to check the device
and verify that all its components (handle, jamming
cleat, flanges) are faultless and in good working
condition.
Packing, storage, maintenance and cleaning
Each product is packed with its INSTRUCTIONS
FOR USE in a cardbox. Proper maintenance and
storage are imperative to ensure correct functioning
of the product (as well as all your equipment) and
14 14
MAT-BA-0205-00_20190911_in_Bearbeitung_new_sizze.indd 14 MAT-BA-0205-00_20190911_in_Bearbeitung_new_sizze.indd 14 22.04.2020 09:45:06 22.04.2020 09:45:06