Cleaning - Sony SnapLab UP-CR10L Mode D'emploi

Cleaning

Before cleaning the unit, be sure to set it to standby with
the on/standby button and disconnect the power cord.
When the cabinet becomes dirty
If the cabinet is extremely dirty, soak a clean cloth in
water, or a solution of water and a neutral detergent, wring
out the cloth, and then wipe the surface of the cabinet.
Next, wipe clean with a clean, dry cloth.
To avoid damaging the surfaces of the unit, never use
thinner, benzene, alcohol, or any other type of organic
solvent to clean the unit.
When the display becomes dirty
When the display has become considerably dirty, wipe it
clean with a dry cloth or with a clean cloth soaked in water
and thoroughly wrung out. Do not use even a mild
detergent, as it can damage the surface of the display.
Never touch or strike the surface of the display with a hard
object.
When the filter for the cooling fan
becomes dirty
When the filter for the thermal head cooling fan has
become considerably dirty, remove it and rinse off the dirt
with water. Do not scrub the filter mesh with a brush or
other cleaning tool.
When cleaning the inside of the printer
When cleaning the print head, use the supplied cleaning
cartridge. For details, refer to the operating instructions
supplied with the cleaning cartridge.
To clean the printer roller, use a soft cloth moistened with
cleaning alcohol to gently wipe the roller while turning it.
53
Cleaning