Sony SnapLab UP-CR10L Mode D'emploi page 11

• An IC board is incorporated in the ribbon cartridge. Do
not touch the terminal of the IC board with anything,
including your fingers or metallic objects. Also, do not
strike, bend, or drop the IC board.
Attaching adaptors to paper holder
Paper roll widths vary according to the print pack. When
using the 2UPC-C14 print pack, attach an adaptor to the
paper holder to compensate for the width difference.
1
Open the front door.
2
Press the paper holder release button and pull the paper
holder out.
3
IC board
4
Press the latch on top of the paper holder and open the
holder.
Adjust the width of the paper holder.
When using the print pack 2UPC-C14
Attach adaptors to both ends of the paper holder.
Memo
Make sure the color of the label on the upper part of the
adaptors matches the color of the label on the paper
holder.
Note
Insert the adaptors firmly and completely into the
paper holder.
11
Installation