Connection To A Computer - Sony SnapLab UP-CR10L Mode D'emploi

Connection to a Computer

To control the unit from a computer, you must connect the
unit to the computer using a commercially available USB
cable. Plug the USB cable into the USB port (device) on
the rear of the unit.
When making the connection, you should also consult the
documentation of the computer.
Note
If the connection is made via a USB hub, correct operation
is not assured.
Attaching a ferrite core to a USB cable
Before connecting a USB cable (not supplied) to the
printer, you should attach a supplied ferrite core to its cable
for noise prevention. To conform to radiation standards,
attach the supplied ferrite core to the USB cable of your
device as described below.
1
Release two stoppers on the ferrite core to open it.
2
Slip the USB cable through the ferrite core and
position it at the base of the USB connector to the
printer.
3
Close the ferrite core until you hear a click.
Note
When the ferrite core cannot be secure because the USB
cable is thin, secure it using a tape.
48
Printing From a Computer
USB cable
Computer