Maintenance And Cleaning; Error Codes - IKA Roller 6 basic Mode D'emploi

The device operates maintenance-free.
For cleaning disconnect the main plug.
• Wear protective gloves when cleaning the devices.
• Do not place electrical appliances into the cleaning agents
for cleaning purposes.
• Do not allow moisture to get into the appliance when
cleaning.
• Please consult with IKA before using any cleaning or de-
contamination methods, other than those recommended
here.
Only clean IKA appliances using these IKA approved cleaning
agents: water containing surfactant / isopropyl alcohol.
IKA Roller 6/10 basic
In case of a fault, a beep is heard and the "Power" LED flashes.
Proceed as follows in such cases:
1. Switch the device off.
2. Perform corrective measures as described below.
3. Perform a restart.
Error Cause
Motor blockage or overload
If the actions described fail to resolve the fault or another error code is displayed then take one of the following steps:
• Contact the IKA service department,
• Send the device for repair, including a short description of the fault.
IKA Roller 6/10 digital
The fault is shown by an error code in the display as following if the error occurs, e.g. Er 4.
Proceed as follows in such cases:
1. Switch the device off.
2. Perform corrective measures as described below.
3. Perform a restart.
Error Cause
Er 3 Temperature inside device is too
high
Er 4 Motor blockage or overload
If the actions described fail to resolve the fault or another error code is displayed then take one of the following steps:
• Contact the IKA service department,
• Send the device for repair, including a short description of the fault.

Maintenance and cleaning

Spare parts order
When ordering spare parts, please give:
•
•
•
Repair
In case of repair the device has to be cleaned and free
from any materials which may constitute a health hazard.
For this you should use the downloaded print of the "Certificate
of compliance" form from the IKA website www.ika.com.
If you require servicing, return the appliance in its original pa-
ckaging. Storage packaging is not sufficient. Please also use sui-
table transport packaging.

Error codes

Effect Solution
Motor off • Switch the device off.
• Reduce the load on the motor and check all moving parts for
freedom of movement.
• Then perform a restart.
Effect Solution
Motor off • Switch the device off.
• Allow the device to cool down.
Motor off • Switch the device off.
• Reduce the load on the motor and check all moving parts for
freedom of movement.
• Then perform a restart.
Machine type
Manufacturing number, see type plate
Item and designation of the spare part, see www.ika.com,
spare parts diagram and spare parts list
15